multi point chimney inspection

Five-point chimney check that catches creosote, cracks, and leaks early

Multi point chimney inspection in Anderson Township, Ohio

A multi point chimney inspection in Anderson Township, Ohio covers the firebox, damper, flue, cap, and crown in one visit. We run a camera down the flue, check for creosote buildup and cracked flue tiles, and hand you photos of anything that needs work. If you burn wood or gas, this is the check that keeps your home safe before winter.

Live phone supportUpfront optionsBacked workmanship
Call firstLive triage can help before arrival
Safety before speedRisks assessed before work begins
Diagnose the causeWe trace the source, not just the symptom
Approve the repairScope and price explained upfront

What's included

What our multi point chimney inspection includes

Every multi point chimney inspection in Anderson Township, Ohio covers the full chimney system, not just the flue. We check the firebox, damper, smoke chamber, flue liner, cap, crown, and exterior masonry. You get a camera scan, a written report, and photos of anything that needs repair. A sweep is added only when creosote is past one-eighth of an inch.

01

Firebox and damper check

We inspect the firebox for cracked firebrick and mortar gaps, and test the damper to make sure it seals. A damper that stays open wastes heat and can push carbon monoxide into the room. We flag any damage and quote the repair upfront.

02

Flue camera scan

An inspection camera goes down the flue to check the chimney liner and flue tiles. We measure creosote buildup and look for cracked flue tiles, gaps, and chimney blockage. This is the step that catches problems a ground-level look would miss.

03

Cap and crown inspection

We check the chimney cap and crown from the roof. A damaged chimney cap lets water and animals in, and a cracked crown lets water destroy mortar and firebrick. We seal minor cracks and quote replacement when the damage is past patching.

04

Exterior masonry review

We look at the exterior brick and mortar joints for spalling, cracks, and chimney leaks around the flashing. Anderson Township freeze-thaw cycles crack mortar fast. Catching it early saves you from a full chimney rebuild later.

05

Written report with photos

You get a written report listing every finding, with photos of anything that needs work. We separate what needs fixing now from what can wait. If repairs are needed, the quote is upfront before any work starts.

Service overview

What a multi point chimney inspection in Anderson Township, Ohio covers

A multi point chimney inspection in Anderson Township, Ohio is a top-to-bottom evaluation that checks every component of your chimney system, not just the flue. We inspect the firebox, damper, smoke chamber, flue liner, chimney cap, crown, and exterior masonry. We run an inspection camera down the flue to spot cracked flue tiles, creosote buildup, and chimney blockage you cannot see from the ground. A flashlight and drop cloth come out first, then the camera goes in. You get a written report with photos and a clear list of what needs fixing now versus what can wait.

Anderson Township homes take a beating from freeze-thaw cycles along Clough Pike and Five Mile Road, and that cracks mortar and chimney crowns fast. Most of the housing stock here was built between the 1970s and 1990s, so original flue tiles are aging out. We also see nesting animals and damaged chimney caps after windy springs. If you have not had a comprehensive chimney check Anderson Township Ohio in the last 12 months, creosote could be sitting at a quarter-inch or more inside your flue, which is the level where a chimney fire becomes a real risk.

Catch creosote before it ignitesCreosote buildup past one-eighth of an inch is flammable. Our inspection camera measures the glaze inside your flue and tells you exactly how much is there. If it is past the safe limit, we schedule a chimney sweep before you light another fire. That one measurement is the difference between a clean burn and a 2 a.m. fire call.
Find cracked flue tiles earlyCracked flue tiles let heat and carbon monoxide escape into your home's framing. We spot hairline cracks on camera that a ground-level look would miss. Repairing a cracked tile runs far less than rebuilding a chimney chase, and it keeps your family safe. We flag every crack by location so you know exactly what we found.
Stop chimney leaks at the crownA cracked chimney crown lets water in, and water destroys mortar, firebrick, and the chimney liner over time. We check the crown, cap, and flashing on every multi point chimney inspection service Anderson Township visit. If we find a leak path, we seal it before the next hard rain. That saves you from a $3,000-plus rebuild down the road.
Chimney repair near me for Anderson Township homes
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.

The service timeline

How our five-point chimney inspection works

The process flexes to the condition, but these checkpoints keep decisions clear.

01

Exterior check

We start outside with a ladder and check the chimney cap, crown, flashing, and masonry from top to bottom. We look for damaged chimney cap, cracked mortar joints, and chimney leaks around the flashing. This takes 10 to 15 minutes on a typical Anderson Township roof. You get photos of anything that needs attention.

Stage 1
02

Firebox and damper

Inside, we open the damper and inspect the firebox, smoke chamber, and damper door. We check for cracked firebrick, mortar gaps, and a damper that does not seal. A drop cloth goes down first so your hearth stays clean. This step takes about 10 minutes and tells us how well your fireplace is drafting.

Stage 2
03

Flue camera scan

We run an inspection camera down the flue to check the chimney liner and flue tiles. We measure creosote buildup and look for cracked flue tiles, gaps, and chimney blockage. This is where most problems show up. The scan takes 15 to 20 minutes and gives you a clear picture of what is inside your chimney.

Stage 3
04

Creosote and debris removal

If creosote is past one-eighth of an inch, we sweep it out with a chimney brush and chimney rods, then vacuum the dust with a vacuum system. We remove any nesting animals or debris. Most sweeps add 30 to 45 minutes to the visit. You leave with a clean flue and a clear burn rating.

Stage 4
05

Report and recommendations

We walk you through the findings, show you the photos, and give you a written report. You get a clear list of what needs fixing now and what can wait. If repairs are needed, we quote them upfront before any work starts. No surprises, no pressure.

Stage 5

Tools & methods

Tools and methods we use on every inspection

Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.

01

Inspection camera

We run a camera down the flue to check the chimney liner and flue tiles. It finds cracked flue tiles and creosote glaze you cannot see from the ground.

02

Chimney brush and rods

Used to sweep creosote from the flue when buildup is past one-eighth of an inch. We size the brush to your flue so the liner is not damaged.

03

Vacuum system

Contains soot and dust during the sweep so your living room stays clean. We run it the whole time the brush is in the flue.

04

Creosote scraper

Scrapes glaze-stage creosote off flue tiles and the firebox. Glaze creosote is the hardest stage to remove and the most flammable.

05

Drop cloth and flashlight

Drop cloths protect your hearth and floor. The flashlight gives us a first look at the firebox and damper before the camera goes in.

06

Ladder

Gets us to the roof safely to check the chimney cap, crown, and flashing. We use OSHA safety practices on every roof.

Use cases

When to book a multi point chimney inspection

These examples show how the service framework adapts rather than forcing every call through one repair.

multi point chimney inspection
Quarter-inch creosote swept cleanA homeowner near Clough Pike had burned wood for four years without a sweep. The camera showed creosote at a quarter inch and a cracked flue tile near the top. Smoke smell lingered in the living room after every fire. → We swept the flue with a chimney brush and rods, vacuumed the dust, and flagged the cracked tile for liner repair. Creosote dropped below one-eighth of an inch. The smoke smell cleared, and the fireplace drafted correctly on the next burn.

Crown crack sealed before rebuild

A Beechmont homeowner saw water stains on the ceiling after a heavy spring rain. The multi point inspection found a cracked chimney crown and failed flashing. Mortar joints near the top were already spalling. → We sealed the crown, reworked the flashing, and repointed the spalled mortar joints. The leak stopped through the next storm. The repair cost a fraction of the $3,000-plus rebuild the damage would have caused in another winter.

Bird nest cleared, backdraft fixed

A Cherry Grove homeowner had smoke roll into the room every time they lit a fire. The inspection found a bird nest blocking the flue and a damper that would not seal. The chimney had no cap. → We removed the nest, fitted a new chimney cap, and repaired the damper. The first fire after that burned clean with no smoke in the house. The cap keeps animals out going forward.

Problems we solve

Chimney problems we solve for Anderson Township homeowners

Most chimney problems start small and get expensive fast. Our multi point chimney inspection catches them while they are still cheap to fix.

ISSUE

Creosote buildup past the safe limit

We measure creosote with an inspection camera on every visit. If it is past the safe limit, we sweep the flue with a chimney brush and rods, then vacuum the dust. You get a clean flue and a clear burn rating before you light another fire.

SYMPTOM

Cracked flue tiles leaking carbon monoxide

Our camera scan finds hairline cracks and gaps in the flue tiles. We flag each one by location and quote a liner repair. Fixing a cracked tile costs far less than rebuilding the chimney chase after a leak or fire.

SIGN

Chimney leaks around the crown and flashing

We check the crown, cap, and flashing on every multi point chimney inspection service Anderson Township visit. Minor crown cracks get sealed. Failed flashing gets reworked. You stop the water before it causes a $3,000-plus rebuild.

ALERT

Nesting animals and chimney blockage

We check the cap and damper for nesting animals and debris. If we find a nest, we remove it and fit a proper cap so it does not happen again. You get a clear flue and a cap that keeps animals out.

Pricing process

What a multi point chimney inspection costs

$150 - $350 depending on chimney height, roof pitch, and whether a sweep is added

Phase 01

Chimney height and roof pitch

A tall chimney on a steep roof takes longer to access and inspect safely. That adds time and ladder work, which moves the price toward the higher end of the range.

Phase 02

Creosote level

If creosote is past one-eighth of an inch, we add a sweep. The sweep uses a chimney brush, rods, and vacuum system, and adds 30 to 45 minutes to the visit.

Phase 03

Number of flues

A chimney with two or three flues takes longer to inspect. We run the camera down each flue separately and report on each one. More flues means more time.

Questions before we arrive

Chimney inspection questions from Anderson Township homeowners

multi point chimney inspection
Call (844) 799-4703
How much does multi point chimney inspection cost in Anderson Township Ohio?

Most multi point chimney inspections in Anderson Township run $150 to $350 in 2026, depending on chimney height, roof pitch, and whether a sweep is added. A basic five-point check with camera scan sits at the lower end. If creosote is past one-eighth of an inch and we sweep the flue, expect the higher end. We quote the full price before we start.

What does multi point chimney inspection include in Anderson Township?

It includes a check of the firebox, damper, smoke chamber, flue liner, chimney cap, crown, and exterior masonry. We run an inspection camera down the flue to measure creosote buildup and look for cracked flue tiles. You get a written report with photos and a clear list of what needs fixing. A sweep is added only if creosote is past the safe limit.

How often should I get multi point chimney inspection in Anderson Township Ohio?

Get a multi point chimney inspection in Anderson Township, Ohio once a year if you burn wood, and every two years for gas-only fireplaces. NFPA 211 recommends annual inspection for solid-fuel chimneys. Anderson Township freeze-thaw cycles crack mortar and crowns fast, so annual checks catch damage before it spreads. Book in late summer before the first fire.

Can you inspect my chimney if I have not had it swept in years?

Yes. We inspect first, then sweep only if the camera shows creosote past one-eighth of an inch. If your flue has heavy creosote buildup, we sweep it the same visit with a chimney brush and chimney rods, then vacuum the dust. You get a clean flue and a clear report. No extra trip, no extra charge beyond the sweep quote.

Ready when you are

Book your multi point chimney inspection in Anderson Township, Ohio

Creosote past one-eighth of an inch is the level where chimney fires start. We run a camera down your flue, measure the buildup, and show you the photos. Call True Revive Tech at (844) 799-4703 and get on the schedule this week.

multi point chimney inspection

Talk with the local team

Request multi point chimney inspection

Call (844) 799-4703 and tell us what your chimney is doing. We answer around the clock for emergencies and book standard sweeps and inspections Monday through Friday, 8 a.m. to 6 p.m. Most Anderson Township calls get a same-week appointment, and we will tell you on the phone whether it can wait or needs a truck today.

2111 Beechmont Ave, Cincinnati, OH 45230, USA, Anderson Township, OhioMain office · technicians serve the full area

Thanks — your request is in. We will contact you shortly.

Call now